HP StoreVirtual 4000 User Manual page 84

Changing the replication level of this volume will cause it to restripe, and may impact IO
performance.
Request Syntax
cliq provisionVolume clusterName= volumeName= description= size= mountPoint= login=
userName= passWord=
userName
passWord
groupName
clusterName
volumeName
description
replication
minReplication
thinProvision
initialQuota
reserveQuota
scratchQuota
mountPoint
stridePages
namePrefix
vipLoadBalance
targetSecret
84 | HP Lefthand CLI | Commands
login Required
Conditional
Conditional
Conditional
Required
Required
size Required
Optional
Optional
Optional
parity Optional
checkSum Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
The IP addresses or DNS-resolvable names of one or more storage
systems
The authentication user name for the storage system. (Parameters
userName/passWord or groupName must be specified).
The password for the storage system. (Parameters userName/passWord
or groupName must be specified).
The name of the management group with cached credentials.
(Parameters userName/passWord or groupName must be specified).
The name of the cluster
The name of the volume
The size of the volume, with units specified: <n>MB - n Megabytes
(1024 Kilobytes), <n>GB - n Gigabytes (1024 Megabytes), <n>TB - n
Terabytes (1024 Gigabytes)
Optional description
The replication level for the volume (1|2|3|4)
The minimum replication allowed for the volume before it goes offline
(1|2|3|4). Note: the minReplication value must be equal to or less than
the replication value on the volume.
The number of parity storage systems for the data on this volume. This
enables parity network RAID on the volume. Replication and parity
are supported in the following combinations: replication:1, parity:0
Network RAID-0 (None), replication:2, parity:0 Network RAID-10
(2-way Mirror), replication:3, parity:0 Network RAID-10+1 (3-way
Mirror), replication:4, parity:0 Network RAID-10+2 (4-way Mirror),
replication:2, parity:1 Network RAID-5 (Single parity), replication:3,
parity:2 Network RAID-6 (Dual Parity)
0 - the volume does not use checksums1 - the volume uses checksums
0 = the volume does not use thin-provisioning, 1 = The volume is thin-
provisioned (in a thinly provisioned volume, reserve may be < length)
The initial quota for the volume, as a percentage or size - the volume
resets to this initial size when a snapshot is taken
The reserve quota for the volume, as a percentage or size - this is the
size guaranteed to be available for this volume, regardless of space
allocated to other objects in the system
The scratch quota for the volume, as a percentage or size - this is the
size guaranteed to be available for snapshots of this volume, regardless
of space allocated to other objects in the system
The drive letter or mount point on the host for the volume (LUN will be
uninitialized if not specified)
This is the initial stride setting for the volume - this must be a power of 2
(1,2,4,8)
A prefix string for newly created objects. A unique number value will be
concatenated to this prefix to guarantee name uniqueness.
Use VIP load balancing for this host. This can be one of: 0 = disabled
or 1 = enabled, 1 is the default.
The CHAP target secret for the volume.