HP StoreOnce B6000 Configuration Manual page 20

Target Name
03.com.hp:storage.d2d.cr209107ff.500110ad6bd1034b.library
1 .robotics
Target Alias
No. of Target Addresses : 1
Target Address # 1
-------------------
IP Address
iSCSI TCP Port
iSCSI Portal Group Tag
User Configured:
----------------
Authenticaton Method
CHAP Method
Initiator CHAP Name
CHAP Secret
Header Digest
Data Digest
7. To optionally configure uni-directional CHAP authentication you should update the iSCSI
Authentication details in the Web Management Interface, as shown below.
NOTE:
the appropriate information for <iqn...>, <chap_password> and <chap_username>.
Once the HP StoreOnce Backup System has been modified, the operating system should be
modified as follows:
# iscsiutil
# iscsiutil
# iscsiutil
# iscsiutil
8. If CHAP authentication has been enabled, rediscover operational target devices by typing the
following:
# ioscan -H 255
The output will be similar to this:
H/W Path
==================================================
255/0
255/0/0.0
255/0/0.0.0
255/0/0.0.0.0
255/0/2.0
255/0/2.0.0
255/0/2.0.0.0
9. If the device type shown above is UNKNOWN instead of TAPE or AUTOCH then you must
configure the stape and schgr modules for the HP-UX kernel. This can be done as follows:
HP-UX 1 1i V2
20 HP-UX 1 1i V2/V3 (PA-RISC & IA64)
In the following commands, items in parentheses are user-defined strings. Substitute
t authmethod CHAP None
u H CHAP_UNI
u N <chap_username>
u W <chap_password>
Class
iscsi
ext_bus
target
ext_bus
target
: iqn.1986-
:
: x.x.x.x
: 3260
: 1
:
: CHAP_UNI
:
:
: None,CRC32C (default)
: None,CRC32C (default)
T <iqn...>
T <iqn...>
Description
iSCSI Virtual Node
iSCSI-SCSI Protocol Interface
tape HP
iSCSI-SCSI Protocol Interface
autoch HP
I x.x.x.x
I x.x.x.x
Ultrium 3-SCSI
MSL G3 Series