Ericsson 4422 User Manual page 18

Start the Phone – Log On/Off
Â
Â
18
LAN access control (network authentication)
(Dialog 4422 v. 2 phone only).
Your telephone might require a network authentication to gain
access to the network. In this case you must enter a valid user
identity and password.
Note: The user identity and password used for the network
authentication is not the same user identity and password
you use to log on. The password is obtained from, and can
only be changed by the system administrator.
LAN access control
Enter user ID:
z
Enter your user identity.
(The Minus key is used to remove a wrong entry.)
Press.
If a password is not required, the display shows your extension
z
number, and the phone is ready for use.
Enter your password.
(The Minus key is used to remove a wrong entry.)
Note: The password can be entered with letters or
numbers, see section
page 24.
Press.
If your user identity and password are accepted, the
phonecontinues with the startup procedure.
Note: If your user identity and password are not accepted,
contact your system administrator.
"Entering letters and
BusinessPhone – Ericsson Dialog 4422 IP Office
numbers" on