Removing Packaging Materials - HP StorageWorks XP10000 - Disk Array Manual

CAUTION:
Any movement of the equipment by forklift should be done prior to unpacking. The carton assembly provides
the most secure support of the equipment during movement. Transporting the equipment by forklift after
the packaging carton has been removed is not advisable.
CAUTION:
The equipment racks are top heavy and contain very sensitive electronic and mechanical components.
When you move the racks on their casters, the rolling surface must be able to support the equipment weight
and must be free of surface conditions that could cause shock or vibration to the cabinet contents. Avoid
pushing the racks from behind because they may tip over. Instead, pull the racks from the rear to roll them.
Be careful when pulling the racks that they don't tip toward you or fall on you, causing injury. Note that
the rear casters swivel and front casters are fixed and do not swivel.
WARNING!
When using sharp objects or cutting tools, make sure that no part of your body lies in the path of the blade
bit or point.
CAUTION:
When disk array equipment is not located in a data center or computer room, it must be stored in a
controlled area that meets environmental requirements (see "Environmental requirements" on page 31).

Removing packaging materials

The primary rack is labeled DKC AE102A. If you ordered a two-rack system, unpack the primary rack
first because it contains the wooden ramp you will use to unload both equipment racks. See the figures
XP10000 Disk Array Site Preparation Guide 47