Dell PS-M4110 User Manual page 29

accordingly. If the network configuration does not match any of these values, it is recommended to use Auto
Negotiation (the Auto option) or refer to your network equipment manufacturer.
Press the center button to continue to the next CMC Network Settings screen.
5. Select the duplex mode (half or full) that matches the network environment.
NOTE: The network speed and duplex mode settings are not available if Auto Negotiation is set to On or
1000MB (1Gbps) is selected.
If auto negotiation is turned on for one device but not the other, then the device using auto negotiation can
determine the network speed of the other device, but not the duplex mode; in this case, duplex mode defaults to
the half duplex setting during auto negotiation. Such a duplex mismatch results in a slow network connection.
Press the center button to continue to the next CMC Network Settings screen.
6. Select the Internet Protocol (IPv4, IPv6, or both) that you want to use for CMC and press the center button to
continue to the next CMC Network Settings screen.
7. Select the mode in which CMC must obtain the NIC IP addresses:
Dynamic Host Configuration
Protocol (DHCP)
Static
8. If you selected DHCP in the previous step, go to step 10.
To register your DNS server's IP address, press the center button to proceed. If you have no DNS, press the right
arrow key. The Register DNS? screen appears; go to step 10.
Set the DNS IP Address using the right or left arrow keys to move between positions, and the up and down arrow
keys to select a number for each position. When you have finished setting the DNS IP address, press the center
button to continue.
9. Indicate whether you want to configure iDRAC:
– No: Skip to step 13.
– Yes: Press the center button to proceed.
You can also configure iDRAC from the CMC GUI.
CMC retrieves IP configuration (IP address, mask, and gateway) automatically
from a DHCP server on your network. CMC is assigned a unique IP address
allotted over your network. If you have selected the DHCP option, press the
center button. The Configure iDRAC7 screen appears; go to step 9.
You manually enter the IP address, gateway, and subnet mask in the screens
immediately following.
If you have selected the Static option, press the center button to continue to
the next CMC Network Settings screen, then:
– Set the Static IP Address by using the right or left arrow keys to move
between positions, and the up and down arrow keys to select a
number for each position. When you have finished setting the Static IP
Address, press the center button to continue.
– Set the subnet mask, and then press the center button.
– Set the gateway, and then press the center button. The Network
Summary screen displays.
The Network Summary screen lists the Static IP Address, Subnet
Mask, and Gateway settings you entered. Check the settings for
accuracy. To correct a setting, navigate to the left arrow button then
press the center key to return to the screen for that setting. After
making a correction, press the center button.
– When you have confirmed the accuracy of the settings you entered,
press the center button. The Register DNS? screen appears.
NOTE: If the Dynamic Host Configuration Protocol (DHCP) mode is
selected for CMC IP configuration, then DNS registration is also
enabled by default.
29