Dell PS-M4110 User Manual page 226

Table 49. CMC Status
Item
Example: CMC1, CMC2
No Errors
Firmware Version
IP4 <enabled, disabled>
IP4 Address: <address, acquiring>
IP6 <enabled, disabled>
IP6 Local Address: <address>
IP6 Global Address: <address>
Table 50. Chassis/Enclosure Status
Item
User Define Name
Error Messages
Model Number
Power Consumption
Peak Power
Minimum Power
Ambient Temperature
Service Tag
CMC redundancy mode
PSU redundancy mode
Table 51. Fan Status
Item
Name/Location
Error Messages
RPM
226
Description
Name/Location.
If no error occurs then "No Errors" is displayed, else lists
error messages.
Only displays on an active CMC. Displays Standby for the
standby CMC.
Displays current IPv4 enabled state only on an active
CMC.
Only displays if IPv4 is enabled only on an active CMC.
Displays current IPv6 enabled state only on an active
CMC.
Only displays if IPv6 is enabled only on an active CMC.
Only displays if IPv6 is enabled only on an active CMC.
Description
Example: "Dell Rack System". This is settable via CMC CLI
or Web GUI.
If no errors occur then No Errors is displayed; otherwise
error messages are listed, critical errors first, then
warnings.
Example "PowerEdgeM1000".
Current power consumption in watts.
Peak power consumed in watts.
Minimum power consumed in watts.
Current ambient temperature in degrees Celsius.
The factory-assigned service tag.
Non-Redundant or Redundant.
Non-Redundant, AC Redundant, or DC Redundant.
Description
Example: Fan1, Fan2, etc.
If no error then "No Errors" is shown; otherwise error
messages are listed, critical errors first, then warnings.
Current fan speed in RPM.