Optical Drive (Optional); Removing The Optical Drive - Dell PowerEdge T620 Owner's Manual

Optical Drive (Optional)

Removing The Optical Drive

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. If installed, remove the front bezel.
2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
3. Open the system.
4. If installed, remove the cooling-fan assembly.
5. Disconnect the power/data cable from the back of the drive.
NOTE: Observe the routing of the power/data cable on the side on the system as you remove them from the system
board and the optical drive. You must route these cables properly when you replace them to prevent them from
being pinched or crimped.
6. To remove the optical drive, push the release latch toward the bottom of the system.
7. Slide the optical drive out of the system until it is free of the drive bay.
8. If you are not adding a new optical drive, install the optical drive blank.
9. If applicable, install the cooling-fan assembly.
10. Close the system.
11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
12. If applicable, install the front bezel.
54