Table of Contents
Advertisement
4036-501
Step 2: Scan of side 2
•
The paper is re–fed to the large roll by the counterclockwise rotation of the
exit/reverse roll.
•
After passing over the upper side of the exit gate, the paper actuates the pre-
registration sensor #2. Movement of the paper is then interrupted for a specific
amount of time to synchronize paper feed timing.
•
The paper moves toward the DADF platen glass. The paper is interrupted to
synchronize the feed timing with the scanning timing of the scanner by the
command signal sent from the DADF registration sensor card.
•
The paper moves to the platen glass by the rotation of the large roll. Side 2 of
the paper is scanned at the platen glass.
•
After scanning, the paper moves toward the exit/reverse roll passing the gate
through the lower path. The paper is nipped by the exit/reverse roll.
•
The paper movement is interrupted for a specified time when the end of paper
passes on the exit/reverse sensor.
1-19
General Information
Advertisement
Table of Contents
