Table of Contents
Advertisement
4036-501
In replacing the cable assembly, scan, rear:
Note: The replacement procedures for the cable assembly-scan is similar on the front
side and the rear side. Therefore, only the rear side replacement is mentioned. Perform
replacement on the front side in the same manner.
Note: Replace the cable assembly-scan on either side; do not remove it on the front side
and the rear side simultaneously.
10.
11.
Move the full rate carriage to the center.
Insert the ball of the cable assembly-scan, rear into the groove in the pulley-capstan,
rear.
DADF Repair Procedures
4-67
Advertisement
Table of Contents
