Sp Distance; Surround Back Ch; Crossover Frequency; Double Bass - Onkyo HT-R591 Instruction Manual

m Surround Back Ch
lch:
Select if only one surround back speaker is
connected.
2ch:
Select if two (left and right) surround back speakers
are connected.
• If the "Surround Back" setting is set to "None", this setting
cannot be selected.
N Crossover (Crossover Frequency)
This setting is adwmtageous for the speakers that you
specified as "Small" in the "Sp Config (Speaker
Configuration)" (_ page 42). To get the best bass
performance from your speaker system, you need to set
the crossover frequency according to the size and
frequency response of your speakers.
40Hz, 50Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz,
120Hz, 150Hz, 200Hz
Use the diameter of the smallest speaker in your system
when choosing the crossover frequency.
Over 8 in. (20 cm)
6-1/2 to 8 in. (16 to 20 cm)
5-114 to 6-112 in. (13 to 16 cm)
3-1/2 to 5-1/4 in. (9 to 13 cm)
Under 3-1/2 in. (9 cm)
40/50/60 Hz*6
70/80/90 Hz*6
100 Hz
120 Hz
150/200 Hz* e
*6 Choose the setting suitable for the speaker.
• For a more accurate setting, look up the frequency response ill the
manuals supplied with your speakers and set accordingly.
• Choose a higher crossover frequency if you want more sound
from your subwoofer.
N Double Bass
This setting is NOT set automatically by
Audyssey 2EQ® Room Correction and Speaker Setup
(_ page 27).
On
Off
Turn this setting on to boost bass output by feeding bass
sounds from the front left, right, and center channels to the
subwoofer.
• When the "Subwoofer" setting is set to "No" or the "Front"
setting to "Small", this setting is fixed to "OFF' (3 page 42).
• This setting is set to "On" automatically when the "Subwoofer"
and "Front" settings are set for the first time to "Yes" and
"Large" respectively.
Advanced Operations
3 _ 4 "_',< 5 _ 6_
SETUP %gNN{'7
This setting is set automatically by Audyssey 2EQ Room
1
Correction and Speaker Setup (_ page 27).
J
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener's ears as the sound designer intended.
• These settings are not available in either of the following cases:
- A pair of headphones is connected.
- The "Audio TV Out" setting is set to "On" (3 page 50).
- "ItDMI Ctrl (RIHD)" is set to "On" (3 page 49) and you're
listening through your TV speakers.
N Unit
feet:
Distances can be set in feet. Range: lft to 30ft in
1 foot steps.
meters:
Distances can be set in meters. Range: 0.3m to 9.0m
in 0.3 meter steps.
(The default setting varies from country to country.)
N Left, Front High Left, Center, Front High Right,
Right, Surround Right, Surr Back Right, Surr
Back Left, Surround Left, Subwoofer
Specify the distance from the each speaker to your
listening position.
• Speakers that you set to "No" or "None" in the "Sp Config
(Speaker Configuration)" (3 page 42) cannot be selected.
En-43
©©