Panasonic HDC-TM41PC Owner's Manual page 42

This u nit isput i nto recording pause approx. 0.6 seconds after the LCD monitor isreopened.
• When inQuick start standby mode about 60% ofthe power used i nRecording pause
mode is being consumed, so the recording time will be reduced.
Quick start will not work if there is no SD card inserted.
Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
• Change the mode to
.
1 Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
The status indicator O flashes green and the unit goes
into Quick start standby mode.
3 Open the LCD monitor.
The status indicator O lights red and the unit
is put into recording pause.
• Quick Start Standby Mode is canceled if
about 5 minutes have elapsed
mode is set to [_
• It may take some time for Automatic white balance to adjust.
• In the Quick Start Mode, the zoom magnification becomes 1 x.
• If [ECONOMY] (-) 41) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
• Turn the unit off using the power button.
Starting and stopping of recording and unit on/off can be confirmed with this sound.
u:_]) (Volume low)/IDOl))) (Volume high)
2 Beeps for 4 times
When an error occurs. Check the sentence displayed on the screen. (-) 101 )
42
VQT3J95