Table of Contents
Advertisement
About status indicator during
charging
When the status
indicator
is flashing
at a
particularly
fast
or slow rate, the
following
should
be considered.
Flashing
with approx.
4 second
period
(off for approx.
2 seconds,
on for approx.
2 seconds):
• When the battery
is over discharged
or the
temperature
of the battery
is too high or
low. It can be charged,
but it may take a
few hours to complete
the charging
normally.
• It will flash in 2 second
intervals
when
normal
charging
resumes.
Even in such
cases,
it may start flashing
in 4 second
intervals
until charging
is completed
depending
on the conditions
of use.
Flashing
with
approx.
0.5 second
period
(off for approx.
0.25 second,
on for
approx.
0.25 second):
• The battery
is not charged.
Remove
the
battery
from the unit, and try charging
again.
• Check
that the terminals
of the unit or
battery
are not dirty or covered
with a
foreign
object,
and connect
the battery
correctly
once again.
If a foreign
object or
dirt is present,
turn off the unit before
removing.
• The battery
or environment
is at an
extremely
high or low temperature.
Wait
until the temperature
has returned
to an
appropriate
level and try charging
again.
If
you are still unable to charge,
there
may
be a fault in the unit, battery
or AC
adaptor.
Off:
• Charging
has finished.
• If the status indicator
stays off despite
the
charging
being unfinished,
there
may be a
fault in the unit, battery
or AC adaptor.
Refer to page 109 for details
on the
battery.
About the SD card
When
disposing
of or giving
away the SD
card, note that:
• Formatting
and deletion
of this unit or
computer
only changes
the file
management
information
and does not
completely
delete the data in the SD card.
• It is recommended
that the SD card is
physically
destroyed
or the SD card is
physically
formatted
using this unit when
disposing
of or giving
away the SD card.
To physically
format
the SD card, connect
the unit via the AC adaptor,
select
[SETUP]
_
[FORMAT
CARD]
_
[YES]
from the menu, and then press and hold
the delete/video
light button on the screen
below
for about 3 seconds.
When
the SD
card data deletion
screen appears,
select
[YES], and then follow
the on-screen
instructions.
To physically
format
the SD card, connect
the unit via the AC adaptor,
select
[SETUP]
_[FORMAT
MEDIA]
_
[SD
CARD]
from the menu,
and then press
and hold the delete/video
light button
on
the screen
below for about 3 seconds.
When
the SD card data deletion
screen
appears,
select
[YES], and then follow
the
on-screen
instructions.
• The customer
is responsible
for the
management
of the data in the SD card.
111
VQT3395
Advertisement
Chapters
Table of Contents
