Sony Handycam HDR-PJ600 Operating Manual page 71

Others/Index
Troubleshooting
If you run into a W problems using your
camcorder, follow the steps below.
(Z) Check the list (p. 71 to 73), and
inspect your camcorder.
(_ Disconnect the power source, attach
the power source again after about 1
minute, and turn the camcorder on.
(_) Press RESET (p. 15) using a pointed
object, and turn the camcorder
on. If you press RESET, all settings,
including the clock setting, are reset.
(_) Contact your Sony dealer or local
authorized Sony service facility.
• _ur calncorder maybe required to initialize or
change the current internal recording medimn
(internal memory (HDR-CX260V/CX580V/
PI260/PJ260V/PJ580/PJ580V) or internal hard
disk drive (HDR PJ600/PJ600V/XR260V)) of
},our camcorder, depending on the problem. In
the event of this, the data stored on the internal
memory will be deleted. Be sure to save the
data on the internal memory on other media
(backup) befbre sending your camcorder lbr
repair. We will not compensate you lbr any loss
of internal memory data.
• During repair, we may check a minimum
amount of data stored on the internal memory
in order to investigate the problem. However,
},our Sony dealer will neither copy nor retain
},our data.
• See the "Handycam" User Guide (p. 9) lbr
details on the symptoms of ?,our camcorder, and
"PlayMemories Home" Help Guide (p. 57) on
connecting your camcorder to a computer.
The power does not turn on.
• Attach a charged battery pack to the
camcorder (p. 19).
• The plug of the AC Adaptor has been
disconnected from the wall outlet (wall
socket). Connect it to the wall outlet (wall
socket) (p. 21).
The camcorder does not operate even
when the power is set to on.
• It takes a f_'w seconds for your camcorder to
be ready to shoot after the power is turned on.
This is not a malfunction.
• Disconnect the AC Adaptor froln the wall
outlet (wall socket) or remove the battery
pack, then reconnect it after about 1 minute.
If the functions still do not work, press RESET
using a pointed object. (If you press RESET
(p. 15), all settings, including the clock setting,
are reset.)
• The temperature of your camcorder is
extremely high. Turn off your camcorder and
leave it for a while in a cool place.
• The temperature of your camcorder is
extremely lo_t: Leave your camcorder with the
power of your camcorder on. Turn off your
camcorder and take it to a warm place. Leave
the camcorder there for a while, then turn on
your calncorder.
Your camcorder gets warm.
• 52mr camcorder may become warm during
operation. This is not a malfunction.
The power abruptly turns off.
• Use the AC Adaptor (p. 21).
• In the default setting, when about 2 minutes
have elapsed while you do not operate your
camcorder, the camcorder automatically turns
otfl Change the setting of [Eco Mode] (p. 69),
or turn on the power again.
• Charge the battery pack (p. 19).
Pressing START/STOP or PHOTO does not
record images.
• The playback screen is displayed. Press MODE
to turn on the _ (Movie) or Q (Photo) lamp
(p. 27).