Advertisement
5.
Completing the Installation for All Models
•
Carefully slide the alr condiltoner back into
the cabinet, (in window)
(ptease seek assislance for this procedure)
Reinstall (slide-out-chassis) secudly screws
removed earlier on the (lower left/right) side of
the cabinet. Figo 7
•
Expand the shutter frames (fully) on each side
and secure the top of the frames to the window
aash using one 314" screw & flat washer on
each side. Fig_23
•
Instalf shutter clamp on each side of the (lower)
shutter and secure lo window sill using one
3/4" screw & flat washer on each side. Fig.23
5a,
o
Reinstalling Front Panel Grilh
Posit_ori the front panel assembly on the
cabinet start(ng at the top.The front panel lock
tabs must be Inserted into the retaining slots in
the cabinet,
Repeat thTsprocedure on all sides, making sure
the fresh air vent_ation lever arm and power
cord are properly installed back to their orTginal
poeition_
Secure the front grill to the cabinet using th_
phillips screws removed earlier. Fig'sol & 2
Install the air filter.
Out the second loam seal to fit the opening
between _he top of the inside and oulstde
window.
(Ffg, 24.,)
Some installations may require additional
sealing around lhe window and alr conditioner.
Check for any air leaks and seal where
necessary.
Under very humid conditions, water removal
may be excessive enough to overflow from the
rear of the unit or increase noise levels of the
air conditioner., If this occurs, consider atlaching
a standard drain (garden) hose (not
fnciuded) to the drainplug at the rear of the
unit, allowing condensatfon to run off
conveniently. (Fig, 25.)
,,.._
L
i i iiiii
ch_s=h=
stt,tw
Fig,7
Gt_p
Fig, 23
, . ... FZ-
....._..,,.._,,,...-.-,--,----
Advertisement
