Installing The Slide-Out Chassis Into Cabinet; Reinstalling Front Grill - Danby Designer DAC6003D Use And Care Manual

6. Installing the Slide-Out Chassis into Cabinet:
(please seek assistance for this procedure)
• Carefu]|y slide the air conditioner back into
the cabinet. (in window)
Note: Ground wire must be re-installed
before completing next step,
• Reinsta!l (slide-out-chassis) security screws
removed earlier from the (lower left/rlght) side of
the cabinet. Fig 7
• Expand the shutter frames (fuIly) on each side
and secure the top el the shutter frame to the
window sash using one 3/4" screw & flat washer
on each side_ F'ig, 23
• Install a shutter clamp on each side of the
(lower) shuiler frame and secure to window sill
usrng one 3/4" screw & fiat washer on each aide.
Figo23
7. Reinstalling Front Grill (All Models) :
Before re-Installing the front grill back on the
cabinet, you must re-connect the (male/female)
electrical wire harness between the front gdlt
control panel and the main (cabinet) unit
(Ftg,Sa) Make sure the elecldcai connection is
t_rmiyand securely attached,
• Position the front panel on the cabinet slarfing at
the top. The front panel lock tabs must be
inserted Into the retaining slols in the cabinet.
• Repeat this procedure on all sides, making sure
the fresh air ventilation lever arm and power cord
are properly installed back to their original
position on the front griilo
° Secure the front grilt Io the cabinet using the
phillips screws removed earlier. Fig's, 3 & 4
• Re-install the air filler.
_, Cut the second foam seal to fit the opening
between the lop inside and outsidewindow.
See Fig_24,
- Some installations may require additional sealing
around the _ndow and air conditioner, Check for
any air teaks and seat where necessary.
• Under very humid conditions, water removal may
be excessive enough to ovedlow from the rear of
the unit or increase noise Ievels of the air
conditioner.If thisoccurs, you may want to attach a
section of (garden) drain hose (not included) to
the drain plug located at lhe rear of the unit, thts
wtll permit condensation to run off more
conveniently. See Fig.25
Fig 7
Shutter
r-_Clamp
Fig, 23
-- 2rid Foam
Seal
Fig,, 24
j =1 H -
r
t'_'_,_ Dta}n Hose
(nol intruded)
Fig, 25