Cub Cadet RZT42 Operator's Manual page 10

3.
f
Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in Fig. 3-3
and securely tighten the hardware.
Discharge =
Chute , i;"........................
Deflector
Push
Carriage B_
J
Figure 3-3
2.
F
Install Operator'sSeat
To install the seat proceed as follows:
NOTE:The seat is shipped with the seat switch and seat pan
attached.
I. Cut any straps securing the seat assembly and the drive
control levers to the tractor. Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting the
seat and the seat switch.
Remove the two shoulder bolts and lock nuts in the seat
pan as shown in Fig. 3-4.
f_
Ji
Seat Pan
Shoulder
Bolt
Figure 3-4
SECTION 2--
ASSEMBLY &
SET-UP
3.
Rotate the seat into position and secure the seat into place
with the previously removed shoulder bolts and lock nuts.
Be careful not to crimp or damage the wire harness while
installing the seat. See Fig. 3-5.
Harness
Seat Bracket
Shoulder
Bolts
, J
Figure 3-5
Position Drive Controllevers
The drive control levers of the tractor are lowered for shipping
purposes. The flange lock nuts, hex screws, and flat washers that
normally secure the control levers in their operating position
are unfastened and installed in the slotted holes of the control
levers for shipment. The control levers must be repositioned to
operate the tractor. To reposition the control levers for operation,
proceed as follows:
1. Remove the hex screw, flat washer, and flange lock nut
from the slot of one of the drive control levers.
2.
F
Lift and swing that control lever upward until the slotted
hole in the lever bracket aligns with one of the holes in the
pivot bracket. See Fig. 3-6.
Control
_ Flange
Lock Nut
/.J
Lift Control
Lever U pwa rd
Pivot
Washer
Figure 3-6
,J