Engine; To Adjust Throttle Control Cable; To Adjust Carburetor - Craftsman 917.293492 Owner's Manual

ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
1. The throttle control has been preset at
the factory and adjustment should not
be necessary If adiustment is
necessary iPro_eed as folio',',',
lhrolflo COnTrolle'¢er IO fAST
pos_Tvorl
3 If throttle level on #r_,:l,,_' lfl;Ir'h¢'_*
h,(lh
Sp("e(J Sf'f, nO
ftlflher
ar_JUkTt*l_l'_f'll IS
necessary If throttle le',,Pf dqo(_ nol
Ic)uCh h_qh Si_¢'e,'I STop
cenT,hue
wilh
adlu£Tmenl pfc_edure
4 Loosen cable clamp screw.
5. Move lhrottle lever up until it touches
high speed stop, and hold in this
position.
6. Tighten cable clamp screw securely.
Clamp Screw
Cnac_i_re "% X% •
Governor' Cont__rol_
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary. However, engine perfor-
mance can be affected by differences in
fuel, temperature, altitude or load. If the
carburetor does need adjustment, contact
your nearest authorized service center/
department
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous. If you think the
engine-governed high speed needs
adluMing
contact your nearest sears or
other
quahfied
service center which has
the proper equipment and experience to
make any
necessary adjustments.
19