Adjusting Upper Blade Guard Assembly; Aligning The Table Square To The Blade - Craftsman 113.244580 Owner's Manual

Alignment (Adjustments) (continued)
Adjusting Upper Blade Guard Assembly
The upper blade guard assembly should always be set
about 1/8" above or as close as possible to the top sur-
face of the workpiece being cut.
Upper Slide
Lock Knob
1. Loosen the upper slide lock knob.
Upper Guard Assembly
2. Rotate the upper slide adjusting knob to position the
guard assembly to the desired position.
3. Tighten the upper slide lock knob.
Upper Slide
Adjusting Knob
Aligning the Table Square to the Blade
I WARNING: Turn off saw, remove switch key and
unplug before adjusting.
1. Loosen the upper slide lock knob and position the
guide assembly all the way up. Tighten the lock knob.
2. Loosen table lock knob.
3. Place a small square on the table beside the blade as
illustrated.
4. Holding the left edge of the table (near the zero stop
set screw), tilt the table up or down to align table 90 ° to
blade (0 ° position). Tighten lock knob,
5. Adjust the zero stop set screw using the 1/8" hex
wrench until the set screw just touches the frame.
6. Check squareness of blade to table. Make readjust-
ments if necessary.
7. Check table bevel indicator for accuracy, Loosen screw
and adjust if necessary. Retighten screw.
Zero Stop
Set Screw
12