Craftsman 152.229010 Instruction Manual page 22

Figure 15-3 Figure 15-5
M
J
J
6, Loosen the two screws (U)on the face (J) of the bft
side Uaser, See Figure 15-3,
7, On the alignment pin (A) there is a verticaU fine
scribe (L) into it, This is used to set parafleHsm of
the Uasers, See Figure 15-4,
8, Using knob (K), rotate the Uaser beam untiU it is
exactly on the vertbaU Hne (L) on the alignment pin,
The chuck and alignment pin may need to be rotat-
ed to aflow the Uaser beam to fail onto the vertbaU
Hne, See Figure 15-3 and 15-4,
9, Tighten screws (U), making sure the Uaser beam
does not move off the vertbaU line (L), See Figure
15-3 and 15-4,
Figure 15-4
K
11,
12,
13,
14,
15,
16,
17,
Adjust the drill press table so that it is about
1" under the alignment pin,
Lay a 3/4" piece of wood (M) onto the drill press
table under the line pin, See Figure 15-5,
Using the drift press feed handle, lower the align-
ment pin down and mark (N) the wood, Make sure
the wood does not move, See Figure 15-5,
Loosen the screw (F) in the top, left side of the
laser housing and using knob (G) located on the
underside of the laser housing, rotate the laser
beam (0) until crosses mark (N) in the wood, See
Figure 15-2 and 15-5,
Tighten screw, making sure the laser beam does
not move off the mark,
Repeat STEPS 14 and 15 to set the right side laser,
Move the wood about 1" and mark it again, check-
ing that the mark is position where the two laser
beams cross, if it does not repeat STEPS 13
through 16 above,
\
\
10, Repeat STEPS 2 through 9 to setup the right side
laser,
22