Flexible Lamp; Table Operation - Craftsman 152.229010 Instruction Manual

FLEXUBLE LAMP
To reduce the risk of fire, use 40 watt or less, 120 volt,
reflector track-type Hight buib (not supplied), DO NOT
use a standard househoid Hight buib, The reflector track-
type Hightbuib shouid not extend bellow the iamp shade,
Figure 9-1
B
A
© ©
The flexible lamp (A) operates independently of the drill
press and has its own power cord, To turn the lamp ON
and OFF, rotate the switch (B) in the clockwise direction
only, See Figure 9-1,
CAUTION: The flexible lamp housing wiii remain hot for
a few minutes after turning it OFR Avoid contact with
housing until it is cook
TABLE OPERATION
Figure 10-1
B
C
1, To raise or lower the table (A) on the column (B),
loosen the table lock handle (C), See Figure 10-1
and 10-2,
Figure 10-2
A
E
18
2, Turn the table raising and lowering handle (D)
clockwise to raise the table and counter-clockwise
to lower the table, See Figure10-2,
3, After the table is at the desired height, tighten the
table height lock handle,
NOTE: Always raise (rather than lower) the table to the
final position to allow the gears to mesh and prevent
slippage,
4, The table (A) can be rotated 360 degrees by loos-
ening the table rotation lock handle (E) and rotating
the table to the desired position, and tightening the
table clamp, See Figure 10-2,
NOTE: For thru-drilling operations, make sure the table
center hob is aligned with the drill bit,