Advertisement
Available languages
Available languages
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new lawn mower.
IMPORTANT: This lawn mower is shipped
WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been as-
sembled at the factory with the excep-
tion of those parts left unassembted
for
shipping purposes.
To ensure safe and
proper operation of your lawn mower, all
parts and hardware you assemble must be
tightened securely.
Use the correct tools
as necessary to ensure proper tightness.
All parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have
been placed in the parts bag.
TO
REMOVE
LAWN
MOWER
FROM
CARTON
1.
Remove
loose parts included
with
mower.
2.
Cut down two end corners
of carton
and lay end panel down flat.
3.
Remove
all packing
materials
except
padding
between
upper and lower
handle
and padding
holding
operator
presence
control
bar to upper handle.
4.
Roll lawn mower
out of carton
and
check carton
thoroughly
for additional
loose parts.
HOWTO SET UPYOUR
LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
1. Raise lower handle section to operat-
ing position and squeeze the bottom
ends of lower handle towards each
other until the pin in handle can be
inserted into one of the three height
adjustment holes.
2. Remove protective padding, raise up-
per handle section into place on lower
handle and tighten both handle knobs.
3. Remove any packing material from
around control bar.
Your lawn mower handle can be adjusted
for your mowing comfort. Refer to "AD-
JUST HANDLE" in the Service and Adjust-
ments section of this manual.
Operator presence
control bar
LIFT
UF
Mowing
position
Lower handle
SQL
Handle
bracket
Handle pin
/
TO ASSEMBLE
GRASS
CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Catcher
frame
handle
TO INSTALL
ATTACHMENTS
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging or
discharging, see "TO CONVERT MOWER" in
the Operation section of this manual.
6
/
/
Frame
opening
Advertisement
