Using Gyroremote - Sharp XG-P20XE Operation Manual

Conference series lcd projector
Hide thumbs Also See for XG-P20XE:
Table of Contents

Advertisement

Using GyroRemote

Antenna
MENU
Preparation
1
2
• The control range will not be optimized if you do not pull
• The control range under actual operating conditions may
3
• The GYRO RF indicator on the projector flashes green
Operating the screen pointer
1
POINTER
2
Menu Adjustments
1
2
3
4
5
GYRO
6
ACTIVE
• Double click on GYRO ACTIVE, the LED will light and you can
• If you release GYRO ACTIVE located on the back of the unit, you
• For operating over a wide area, move the GyroRemote while
Switch on the projector power source. The projector
image will appear on the screen.
Pull up the projector antenna.
out the antenna. Always use with the antenna fully
extended.
be less than optimum depending on where the projector
is placed and the radio signal environment.
Press POWER on the GyroRemote, located on the
front, inside the upper cover.
whenever it receives a radio signal from the GyroRemote.
Press POINTER on the GyroRemote.
As the POINTER is being pushed, a pointer on the
screen will display. If you release your finger from
the POINTER it will disappear from the screen.
Hold the GyroRemote and move it around freely in
the air. The pointer on the screen moves precisely
in concert with the movement of your GyroRemote
in hand.
For best operating results, hold your arm in a fixed
position and rotate your wrist freely.
Open the upper cover on the front of the
GyroRemote.
Press MENU.
Press GYRO ACTIVE on the back of the
GyroRemote, and select your desired category by
moving the unit left or right.
Then select the desired item by moving the unit up
or down.
Move the unit left or right, or press
item values.
Press MENU.
The menu display disappears.
operate GyroRemote just like pressing the button continuously. To
cancel this mode, press GYRO ACTIVE once.
will not be able to control operations no matter how you wave your
hand in the air.
pressing GYRO ACTIVE. Then release the button and move your
hand back to its former position. Repeat these steps to move further.
/
to adjust
32

Advertisement

Table of Contents
loading

Table of Contents