Sharp AR-M256 Setup Manual page 12

INSTALLING THE SOFTWARE
10
When you are asked how the printer is
connected, select "Connected to this
computer" and click the "Next" button.
11
When the interface selection screen
appears, select "Parallel" and click the
"Next" button.
12
Select the printer port and click the
"Next" button.
Select "LPT1" for the printer port.
10
If "LPT1" does not appear, another printer
Note
or peripheral device is using LPT1. In this
case continue the installation, and after the
installation is finished, change the port
setting so that the machine can use LPT1.
This procedure is explained in "Another
printer is using the parallel port (when
using a parallel cable)" on page 16.
13
When the model selection window
appears, select model name of your
machine and click the "Next" button.
14
Click the "Next" button.
In Windows 98/Me/NT 4.0, click the "Yes"
button.
Begin installation of the printer driver.
15
When "The installation of the SHARP
software is complete" appears, click
the "OK" button.
16
Click the "Close" button.
A message will appear instructing you to
connect the machine to your computer.
Click the "OK" button.
After the installation, a message
Note
prompting you to restart your computer
may appear. In this case, click the "Yes"
button to restart your computer.
17
Turn off the power of the machine and
your computer, and connect the
machine to your computer with the
parallel cable. (page 13)
After connecting the machine to your
computer, turn on the power of the
machine and then start up your computer.
This completes the installation of the
software.
After installation, see "CONFIGURING THE
PRINTER DRIVER" (page 14) to check the
printer driver settings.