Configure The Settings Relating To Panasonic Alarm Protocol [Notification] - Panasonic WV-SP302 Operating Instructions Manual

Configure the settings relating to Panasonic alarm protocol [Notification]

Click the [Notification] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu)
The settings relating to Panasonic alarm protocol can be configured in this section.
■ Panasonic alarm protocol notification
[Panasonic alarm protocol]
Select "On" or "Off" to determine whether or not to pro-
vide notification by Panasonic alarm protocol according
to the settings for the "Alarm" and "Diag." checkboxes
of
"Destination of notification" below.
• When an alarm is detected ("Alarm")
• When a notification of the remaining capacity of the
SD memory card has been provided ("Diag.")
• When the SD memory card has become full ("Diag.")
• When the SD memory card cannot be recognized
("Diag.")
Default: Off
Note:
• When "On" is selected, notification of the alarm
occurrence will be provided to the registered desti-
nation addresses in order (to IP address 1 first, to IP
address 8 last).
[Destination port]
Select a destination port for the Panasonic alarm proto-
col from the following.
Available range: 1-65535
Default: 1818
[Retry times]
Select a retry time for the Panasonic alarm protocol.
Available range: 0 - 30
Default: 2
68
■ Destination of notification
[Address 1] - [Address 8]
Enter the destination IP address of the Panasonic alarm
protocol from the following. Host name is unavailable
for the IP address. Up to 8 destination addresses can
be registered.
"Alarm" checkbox: When the checkbox is checked,
the Panasonic alarm notification will be provided
upon an alarm occurrence.
"Diag." checkbox: When the checkbox is checked,
notification using Panasonic alarm protocol will be
provided in the following cases.
• When notification of the remaining capacity of
the SD memory card has been provided
• When the SD memory card has become full
• The SD memory card cannot be recognized
"Destination IP address": Enter the destination
address.
To delete the registered IP address, click the [Delete]
button respective to the desired IP address.
Important:
• Confirm that the destination IP addresses are regis-
tered correctly. When a registered destination does
not exist, notification may be delayed.