Gigabyte GA-Z77X-UP7 User Manual page 60

& OnBoard USB3.0 Controller#2 (Etron EJ168 USB Controller, USB 3.0/2.0 ports on the
back panel)
Enables or disables the Etron EJ168 USB controller. (Default: Enabled)
& OnBoard LAN Controller#1 (Atheros GbE LAN Chip, LAN1)
Enables or disables the Atheros GbE LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
` Super IO Configuration
This section provides information on the super I/O chip and allows you to configure the serial port.
& Serial Port A
Enables or disables the onboard serial port. (Default: Enabled)
` Intel(R) Smart Connect Technology
& ISCT Configuration
Enables or disables Intel Smart Connect Technology. (Default: Disabled)
` Marvell ATA Controller Configuration
& GSATA Controller (Marvell 88SE9172 Chip, GSATA3 6 and GSATA3 7 connectors)
Enables or disables RAID for the SATA controllers integrated in the Marvell 88SE9172 chip or configures
the SATA controllers to AHCI mode. The area below displays the current status of the two SATA ports.
IDE Mode D isables RAID for the SATA controllers and configures the SATA controllers to IDE
mode.
AHCI Mode C onfigures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
RAID Mode Enables RAID for the SATA controllers.
Disables this function.
Disabled
BIOS Setup - 60 -