Gigabyte GA-Z77X-UP7 User Manual page 11

Storage Interface Š Chipset:
- 2 x SATA 6Gb/s connectors (SATA3 0~1) supporting up to 2 SATA 6Gb/s
devices
- 4 x SATA 3Gb/s connectors (SATA2 2~5) supporting up to 4 SATA 3Gb/s
devices
- 1 x mSATA connector
* The SATA2 5 connector will become unavailable when the mSATA connector is
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the
2 x Marvell 88SE9172 chips:
Š
- 4 x SATA 6Gb/s connectors (GSATA3 6~9) supporting up to 4 SATA 6Gb/s
devices
- Support for RAID 0 and RAID 1
USB Chipset:
Š
- Up to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through
the internal USB header)
- Up to 4 USB 2.0/1.1 ports (available through the internal USB headers)
VIA VL800 chip:
Š
- Up to 4 USB 3.0/2.0 ports on the back panel
* Due to a Windows 7 limitation, please connect your USB device(s) to the Intel
Etron EJ168 chip:
Š
- Up to 2 USB 3.0/2.0 ports (available through the internal USB header)
Internal 1 x 24-pin ATX main power connector
Š
2 x 8-pin ATX 12V power connectors
Š
Connectors
1 x PCIe power connector
Š
6 x SATA 6Gb/s connectors
Š
4 x SATA 3Gb/s connectors
Š
1 x mSATA connector
Š
1 x CPU fan header
Š
6 x system fan headers
Š
1 x front panel header
Š
1 x front panel audio header
Š
1 x S/PDIF Out header
Š
1 x S/PDIF In header
Š
2 x USB 3.0/2.0 headers
Š
2 x USB 2.0/1.1 headers
Š
1 x serial port header
Š
1 x Clear CMOS jumper
Š
1 x power button
Š
1 x reset button
Š
1 x Clear CMOS button
Š
1 x Gear button
Š
1 x CPU BCLK Down button
Š
1 x CPU BCLK Up button
Š
1 x CPU Ratio Down button
Š
1 x CPU Ratio Up button
Š
1 x onboard voltage measurement module
Š
installed with a solid state drive.
system performance of the RAID set may vary depending on the devices being
connected.
controlled USB port(s) (located below the PS/2 keyboard/mouse port) before the
VIA USB 3.0 controller driver is installed.
- 11 - Hardware Installation