Sharp AR-150 SERIES Operation Manual page 28

Fax Setup
10
11
STOP
Step 4 or
Note: You may need to add a pause between certain digits in the number to allow
time for connection. For example, if you are on a PBX telephone system that
requires an access number, such as "9", to be dialed to access an outside
line, you will need to enter a pause between the access number and the fax
number of the other party. Pauses are entered by pressing the REDIAL PAUSE
key (2 seconds per pause). If necessary, several pauses can be entered in a
row.
Use the following procedure to clear numbers:
Step Press these keys
1
FUNCTION
2
3
ABC
4
01
5
ENTER
6
STOP
Step 4 or
2-20
02 INITAL. b(SUK) A5.p65
ABC
or
STOP
DEF
(example)
. . .
STOP
INITIAL SETTINGS
20
Press "1" if you want to specify
the number as a Chain Dialing
number (see "Chain Dialing for
Long Numbers" in this section).
Otherwise, press "2".
Return to Step 4 to store
another number, or press the
STOP key a number of times
until you exit. If the number is a
Rapid key number, you can
write the name on the label
above the appropriate Rapid
key.
. . .
Comments
"ENTRY MODE" will appear in
the display.
"FAX NUMBER MODE" will
appear in the display.
Select CLEAR. "FAX NUMBER
CLEAR" will appear in the
display.
To clear a Rapid key number,
press the appropriate Rapid
key. To clear a Speed Dial
number, enter the 2-digit
number with the number keys.
"PRESS ENTER KEY" will
appear in the display. If there is
no number stored under that
Rapid key or Speed Dial
number, "NO NUMBER
STORED" will appear in the
display.
"CLEARED" will appear in the
display.
Return to Step 4 to clear
another number, or press the
STOP key a number of times
until you exit.
11/10/99, 13:51