Connecting To A Projector On A Different Subnet - Epson PowerLite Pro Z8050WNL Network Operation Manual

Connecting to a Projector on a Different Subnet

Connecting to a Projector on a Different Subnet
By default, this application only searches for projectors on the same
subnet as the computer. Therefore, even if you perform a search for
projectors on the network, ones on a different subnet will not be found.
You can, however, identify and connect to a projector on a different
subnet as follows:
• In Advanced Connection Mode, specify either an IP address or
Projector Name and perform a search.
The IP Address can be input directly. Also, provided the Projector
name to be connected has been registered on the DNS server, you can
perform a search simply by inputting that Projector name.
• In Quick Connection Mode, click "Manual Search" on the EasyMP
Network Projection projector selection screen. You can specify the
SSID. When there are a lot of projectors you can narrow the search field
by using SSID.
• Performing a search based on a Profile
Once you have performed a search for a projector on a different subnet,
you can save the search as a Profile with an easy-to-remember name,
and then use that Profile whenever you subsequently want to search for
a projector on a different subnet.
q
If a search fails to find a projector, the most likely causes are as follows.
Proceed as appropriate, depending on the cause of the failure.
• For both Windows and Macintosh
If there is no wireless LAN signal or if the signal is weak, check whether
there is anything that could be interfering with the signal.
• When the optional Wireless 802.11a/b/g Module is installed in the
projector, and the Macintosh is connected to a Wireless LAN
Check whether AirPort is set to On. Or, check whether an appropriate
access point has been selected.
p.36
s
p.37
s
35