Adjusting The Virtual Display - Epson PowerLite Pro Z8050WNL Network Operation Manual

Using Multi-Screen Display

Adjusting the Virtual Display

After starting EasyMP Network Projection, the setup of the virtual
displays varies between Windows and Macintosh. The procedures are
explained separately below.
q
Check the following points before starting EasyMP Network Projection
when connecting via Wireless LAN. If the following points are not set
correctly, Multi-screen display cannot be used.
• When you use Quick Connection Mode, the SSID for the computer and the
projector must be the same.
• The Wireless LAN system for the computer and each projector must be the
same.
You can modify the SSID and Wireless LAN system for the projector from
the Network menu in the projector's Configuration menu. See your User's
Guide for more information.
Procedure
For Windows
A
Select "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EasyMP Network Projection" to start EasyMP
Network Projection.
B
If the Connection mode screen opens, select "Advanced
Connection Mode" or "Quick Connection Mode" (only
available when the optional Wireless 802.11a/b/g Module is
installed). Then click "OK".
The projector search results are displayed.
To always connect using the mode you selected, select Set the se-
lected Connection Mode as the default mode for future connec-
tions. in the Connection mode screen.
C
Select the "Use multi-display" check box.
Display layout and Display properties are added at the bottom of
the screen.
28