Setting And Adjusting The Projector (Settings & Adjustments); Setting The Security (Network - Security) - Sharp PG-D45X3D Setup Manual

Setting and Adjusting the
Projector
(Settings & Adjustments)
Example: "Picture" screen display for COMPUTER
On these screens, you can make projector
settings or adjustments. You can set or
adjust the following items:
• Picture Mode
• CLR Temp
• BrilliantColor TM
• Progressive
• DNR
• Eco + Quiet Mode
• Resolution Setting
• Signal Type
• Video System
• Dynamic Range
• Resize
• Overscan
• OSD Display
• Background
Note
• If you click the "Refresh" button before the
screen is displayed completely, an error
message ("Server Busy Error") will be
displayed. Wait for a moment and then operate
again.
• You cannot operate this page while the
projector is warming up.
• For details about each item, refer to the
projector's operation manual.
• Projection Mode
® TM
• DLP Link
• DLP ® Link TM Invert
• Video Setup
• OSD Language
• Auto Sync
• Auto Power Off
• Auto Restart
• System Sound
• Audio Out
• Internal Speaker
• Audio Input
• RS-232C Speed
• Fan Mode
• All Reset
Controlling the Projector via LAN
Setting the Security
(Network – Security)
On this screen, you can make settings
relating to security.
Items
User Name Setting of user name for security
protection.
Password Setting of password for security
protection.
Accept IP It is possible to set up to three IP
Address addresses allowing connection to the
projector.
All IP No limits are set to IP addresses
Addresses connecting to the projector.
From only For security improvement, only an IP
specifi c IP address set by "Address 1-3" can be
addresses connected to the projector.
Note
• User Name and Password can be up to 8
characters.
• You can input the characters below:
a-z, A-Z, 0-9, -, _
Description
-17