Carrying Out Network Ping Test; (Advanced[5]Network Ping Test); Setting Of Accept Ip Address (Advanced [6]Accept Ip Addr(1) - [8]Accept Ip Addr(3)); Accepting All Ip Addresses - Sharp PG-D45X3D Setup Manual

Setting up the Projector Using RS-232C or Telnet
Carrying out Network Ping
Test

(ADVANCED[5]Network Ping Test)

It is possible to confi rm that a network
connection between the projector and a
computer etc. is working normally.
advanced>5
Ping Test IP addr :192.168.150.1
Please Enter :192.168.150.152
(change) —> 192.168.150.152
32 bytes from 192.168.150.152: icmp_seq = 1, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 2, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 3, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 4, time = 0 ms
1 Enter "5" and press the "Enter" key.
2 Enter IP address of device to be tested and
press the "Enter" key.
Display entered IP address (*1).
Display test result (*2).
Note
• If the "Enter" key is pressed without entering an
IP address, the Ping Test IP address used
previously is entered.
• If there is a fault with the connection, "Error: No
answer" is displayed after a 5 second retry. In
this case, please confi rm the settings for the
projector and the computer, and contact your
network administrator.
-28
Setting of Accept IP Ad-
dress
(ADVANCED[6]Accept IP
Addr(1) - [8]Accept IP Addr(3))
It is possible to improve security of the
projector by allowing connection from only a
prescribed IP address. It is possible to set up
to three IP addresses allowing connection to
1
the projector.
2
advanced>6
*1
Accept IP Addr(1) : 0.0.0.0
Please Enter
*2
(change) —>
1 Enter "6", "7" or "8" and press the "Enter"
key.
2 Enter numerical value and press the
"Enter" key.
Display set numerical value (*).
Note
• To invalidate the Accept IP Address being
currently set, enter "0.0.0.0".
• If there is one or more Accept IP Addr being
set, no connections are allowed from IP
addresses that are not yet set. They can be
cancelled using [9]Accept All IP Addr.

Accepting All IP Addresses

(ADVANCED[9]Accept All IP Addr)

Removes IP addresses set with "Accept IP
Addr".
advanced>9
Accept All IP Addresses(y/n)? y
1 Enter "9" and press the "Enter" key.
2 Enter "y" and press the "Enter" key.
Note
• At the point in time where "y" was entered, the
numerical values for Accept IP Addr(1)-(3) are
reset to "0.0.0.0".
• If "n" is entered, setting is not altered.
: 192.168.150.152
192.168.150.152
1
2
*
1
2