Table of Contents
Advertisement
3
Press
,
remote control to select the IN-
PUT mode.
• After pressing
use
to select the desired input mode.
Note
• When no signal is received, "NO SIG-
NAL" will be displayed. When a signal
that the projector is not preset to re-
ceive is received, "NOT REG." will be
displayed.
• The INPUT mode is not displayed
when "OSD Display" is set to "OFF".
(See page 44.)
About the INPUT mode
INPUT 1
Used for projecting im-
(RGB/
ages from equipment that
Component)
sends RGB signals or
component signals con-
nected to the RGB input
terminal.
INPUT 2
Used for projecting im-
(S-Video)
ages from equipment
connected to the S-
VIDEO input terminal.
INPUT 3
Used for projecting im-
(Video)
ages from equipment
connected to the VIDEO
input terminal.
4
Press
or
control to adjust the volume.
Note
• Pressing
will lower the volume.
Pressing
will raise the volume.
• On the projector, the volume can be
adjusted by pressing
5
Press
on the remote con-
trol to temporarily display a
black screen and turn off the
sound.
Note
• Pressing
again will turn the pro-
jected image and sound back on.
or
on the
once on the projector,
on the remote
or
.
"On-screen Display (Example)
INPUT 1 mode
Using RGB
Using
Component
INPUT 2 mode
Using S-Video
INPUT 3 mode
Using Video
-27
Advertisement
Table of Contents
