Opening The Drawing By Hand; Installing The Fixing Angle Bracket - Sharp ER-A220 Instruction Manual

Opening the drawer by hand
8
Lever

Installing the fixing angle bracket

9
To prevent the register from moving when the drawer opens, the fixing angle bracket is supplied with the
register. By attaching the bracket to the table where the register is installed, you can hook the register on this
bracket and secure the register to its position.
How to install the fixing angle bracket
A
B
How to remove the register from the fixing angle bracket
58
The drawer automatically opens in the usual way. However, when power
failure is encountered or the machine becomes out of order, slide the lever
located on the machine bottom in the direction of the arrow. (See the figure at
the left.)
The drawer will not open, if it is locked with a drawer lock key.
1.
2.
3.
4.
1.
Thoroughly clean the location where the fixing angle
bracket (B) is to be placed.
Peel off the adhesive tape on the fixing angle bracket.
Hook the angle bracket onto the hook (A) that is located
at the bottom rear of the register.
Firmly stick the fixing angle bracket to the table surface
that your cleaned above.
Lift up the front of the register and pull the register
towards you.