Timer On - Sharp Plasmacluster AE-X12HR Operation Manual

Before setting the timer, make sure the clock is properly set with the current time.

TIMER ON

1
Press the TIMER ON (
2
The TIMER ON indicator will blink; press
the TIME ADVANCE or REVERSE button
to set the desired time.
(The time can be set in 10-minute increments.)
3
Point the remote control at the receiver
window on the unit and press the TIMER
SET (SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it receives
the signal.
4
Select the operation condition.
DISPLAY
MODE
1h
CLEAN
FAN
NOTE:
• The unit will turn on prior to the set time to allow
the room to reach the desired temperature by the
programmed time. (Awaking function)
) button.
) on the unit will
1
2
3
SET/C
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) button.
• The orange TIMER lamp (
off.
• The current clock time will be displayed on the
remote control.
MODE
FAN
NOTE:
• If any TIMER ON, TIMER OFF and ONE-HOUR
OFF TIMER are set, the TIMER CANCEL button
cancels all settings.
TO CHANGE TIME SETTING
Cancel the TIMER setting fi rst, then set it again.
COMBINED USE OF ON AND OFF
TIMERS
You can use the ON and OFF timers in
combination.
Example:
To stop operation at 11:00 p.m. and resume operation
to bring the room temperature to the desired level by
7:00 a.m.
1
Set the TIMER OFF to 11:00 p.m. during
operation.
2
Set the TIMER ON to 7:00 a.m.
The arrow (
indicator and the TIMER OFF indicator shows
which timer will activate fi rst.
NOTE
:
• You cannot programmed the ON-TIMER and OFF-
TIMER to operate the unit at different temperatures
or other settings.
• Either timer can be programmed to activate prior
the other.
E-11
) on the unit will turn
1h
CLEAN
CANCEL
SET/C
or ) between the TIMER ON