Table of Contents
Advertisement
■ Wired LAN
Network > Wired LAN
Assigns a network address to your projector. Select
network assigns addresses automatically. Otherwise, select
address, subnet mask, and gateway address.
Note: You can enter a number from 0 to 255 in each field of the address. For the IP Address
and Gateway Address, you cannot use 0.x.x.x, 127.x.x.x, or 224.0.0.0 through
255.255.255.255. For the Subnet Mask, do not use 0.x.x.x through 254.x.x.x, or
255.255.255.255.
■ Mail
Network > Mail
Turn on
Mail Notification
projector (see page 51).
Select
SMTP Server
Note: You can enter a number from 0 to 255 in each field of the address. You cannot use
0.x.x.x, 127.x.x.x, or 224.0.0.0 through 255.255.255.255.
Select
Port Number
25. You can enter a number from 1 to 65535.
Select an
Address Setting
notified if a problem occurs. You can also select the types of problems about which you
want to be notified.
■ AMX Device Discovery
Network > AMX Device Discovery
When the projector is connected to a network, select
detected by AMX Device Discovery. Select
controller.
if you want to receive e-mail alerts about the status of the
to enter the IP address for your SMTP server.
to enter the port number for the SMTP server. The default value is
to enter up to three e-mail address where you want to be
and set it to
DHCP
and enter the projector's IP
Off
to allow the projector to be
On
if your network doesn't use an AMX
Off
Making Detailed Adjustments
if your
On
47
Advertisement
Table of Contents
