JVC KD-R901 Instructions Manual page 44

Symptoms
• "No Files" appears on the display.
• The iPod's controls do not work after
disconnecting from this unit.
• "Disconnect" appears on the display.
• No sound can be heard when connecting
an iPod nano.
• "Reset 01" – "Reset 07" appears on the
display.
• "Reset 08" appears on the display.
• "No DAB Signal" appears on the display.
• "Reset 08" appears on the display.
• "Antenna Power NG" appears on the display.
• The DAB tuner does not work at all.
• Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
• The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Victor
Company of Japan, Limited (JVC) is under license. Other trademarks and trade names are those of their respective
owners.
• "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been
certified by the developer to meet Apple performance standards.
• "Works with iPhone" means that an electronic accessory has been designed to connect specifically to iPhone and
has been certified by the developer to meet Apple performance standards.
• Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
• iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
• iPhone is a trademark of Apple Inc.
44
Remedies/Causes
No tracks are stored. Import tracks to the iPod.
Reset the iPod.
• Check the connecting cable and its connection.
• Charge the battery.
• Disconnect the headphones from the iPod
nano.
• Update the firmware version of the iPod nano.
Disconnect the adapter from both this unit and
iPod. Then, connect it again.
Check the connection between the adapter and
this unit.
Move to an area with stronger signals.
Connect this unit and the DAB tuner correctly and
reset the unit (see page 3).
Check the cords and connections.
Reconnect this unit and the DAB tuner correctly
and reset the unit (see page 3).