3. Press
. Then use the up and down arrow buttons and the
Enter
button to select any of the following options:
Enter
(computer images)
■
Auto Setup
Leave this setting
image. Turn it off if you want to save adjustments you have
made to the video settings.
(computer images)
■
Tracking
Removes unwanted vertical lines from a computer image by
matching the projector's internal clock to various computer
signals. See page 90 for more information about adjusting the
tracking.
(computer images)
■
Sync
Corrects fuzziness or screen flicker by synchronizing the
projector with the tracking signal sent from the computer.
See page 90 for more information about adjusting the sync
setting.
■
Position
Use the arrow buttons to move the image on the screen left,
right, up, or down.
■
Progressive
Leave this setting
video so that interlaced-to-progressive conversion is carried
out (best for fast-moving pictures). If you notice flickering
while viewing still images, switch this setting to
■
Computer Input
Selects the signal from equipment connected to the
Computer (Component Video)
look wrong, try changing this setting from
following:
RGB
Component Video
to automatically optimize the computer
On
when viewing S-Video or composite
On
port. If your image colors
for computer or RGB video sources, or
for component video sources.
.
Off
to one of the
Auto
Fine-tuning the Projector
note
If you have repositioned the
image but then change your
mind, you can press the
button on the
Enter/Auto
remote control to restore the
default settings.
59