Selecting The Image Source; What To Do If You See A Blank Screen - Epson EX90 User Manual

note
The name of the selected
image source appears in the
upper right corner of the
screen.
Projecting
34
To focus and adjust the image, see page 37. If a projected image fails
to appear, see "What To Do If You See a Blank Screen" on page 34.
When you're done with your presentation, shut down the projector as
described on page 41.

Selecting the Image Source

Selecting the image source lets you switch between images input from
different pieces of equipment connected to the projector (such as a
computer and DVD player). If you don't see the image you want,
press the
Source Search
until the correct device image is projected.
Remote control
If a projected image fails to appear, see the next section for help.
Once you see your image, turn to page 37 for instructions on focusing
and making other image adjustments.

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the message
after turning on your computer or video source, try the following:
Make sure the cables are connected correctly, as described in
■
Chapter 1.
Make sure the power light is green and not flashing and the
■
slide is open.
Mute
Make sure you've selected the correct image source; see the
■
previous section. Allow a few seconds for the projector to sync up
after pressing the button.
button on the remote control or projector
Projector control panel
No Signal
A/V