Log Set Installation - HAMPTON BAY Hampton H25-NG Owners & Installation Manual

INSTALLATION
Read the instructions below carefully and refer to the dia-
grams. If the logs are broken do not use the unit until they are
replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a) Rear Log
b) Left Side Front Log
c) Right Side Front Log
d) Center Front Log
e ) Embers
A)
B)
1) Shut off the gas supply.
2) Lift off the Cast Top and remove the Glass Front (see manual).
3) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
4) Place the rear log on the 2 rear log locating pins on the rear of the
burner with the flat side to the back.
28

LOG SET INSTALLATION

902-299
902-030
902-031
902-029
902-156
C)
A)
5) Place the 2 front logs on the front log locating pins. Ensure the back
of both logs rest against the tabs.
B)
NOTE: This is
a rear view.
Right Front Log
B)
The Front Right Log
front edges should be
placed parallel
against the front edge
of the burner.
C)
NOTE: This is
a rear view.
Hampton H25 Direct Vent Freestanding Gas Stove
Left Front Log
B)
Tabs
A)
C)
C)
Tabs