Door And Drawer Removal - Crosley CB19G6W Use & Care Manual

Installation
3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
C C
4. Using the carpenter's level, make sure front of
refrigerator is '/4" (6 ram) or '/2bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
5. Turn stabilizing legs (C) clockwise until firmly
against floor.
6. Replace bracket cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
7. Replace the toe grille.
Note
• For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
1. Unplug power cord from power source.
2. Remove toe grille and bottom bracket
cover(s) (see page 3).
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
4. Unscrew _,6" hex head screws from
top hinge to remove hinge and retain ,_
all screws for later use.
5. Lift refrigerator door from center
hinge pin.
6. For swing freezer door models
only: Hold freezer door while
removing hinge pin with a Y,6"hex
head driver. Remove door from
bottom hinge and retain hinge pin
for later use.
.
.
.
For pullout freezer drawer models
only: Remove plastic sleeve, if t
Remove center hinge pin with a _,_" hex"
head driver. Retain hinge pin and
plastic sleeve for later use.
Remove Phillips screws to remove
center hinge and retain all screws for
later use.
Remove bottom hinge or stabilizing
bracket with _" hex head driver and
retain screws for later use. Lift out
bottom hinge pin (on freezer door
models).
If your model has a pullout freezer drawer, see
page 5 for drawer removal instructions.