Table of Contents
Advertisement
Getting through narrow spaces
If your refrigerator will not fit through an entrance area, you can reduce its size by removing the doors. Check first by measuring the
entrance.
REQUIRED TOOLS
You will need the following tools:
Top Hinge
Cover Front
Screw
Top
Hinge
Bottom
Screw
Hinge
Screw
TO PREPARE FOR REMOVING THE DOORS:
1 Make sure the electrical power cord is unplugged from
the
2 Open both doors and remove the toe grille (as explained
in the Installation Instructions that came with your appliance).
3 Remove any food from the door shelves.
4 Close the doors.
TO REMOVE THE REFRIGERATOR TOP HINGE COVER:
1 Remove the three screws from each cover over the top door hinges.
2 Lift hinge cover straight up and off.
TO REMOVE THE REFRIGERATOR DOOR:
1 Trace lightly around the door's top hinge with a pencil. This makes reinstallation easier.
2 Remove the two screws from the top hinge. Lift the door off of the bottom hinge and set it aside.
3 Remove the two bottom hinge screws and hinge if necessary.
To reinstall the refrigerator door, reverse the above steps.
Adjustable Hinge
(some models)
Top Hinge
Tools Necessary:
Cover Rear
Screw
™
Phillips Head
wall outlet.
Non-Adjusting Hinge
(some models)
DOOR REMOVAL INSTRUCTIONS
AND
OR
Socket
Wrench Set
CAUTION
Be sure doors are set aside in a secure position where
they cannot fall and cause personal injury.
OR
3/8" Fixed
Adjustable
Wrench
Wrench
7
Advertisement
Table of Contents
