Epson EMP-74 User Manual page 35

Turning On the Projector
If more than one external device is connected to the
4
projector, use the remote control or projector control
panel buttons to select the image source to be
projected while referring to the following table.
Remote control
Button to press
Port
Remote
control
Computer1/
Component
Video1
[Computer1/2]
Computer2/
Component
Video2
S-Video
[S-Video/
Video]
Video
* The items selected using the "Input Signal" command in the "Image"
menu will appear.
Projector
Display at top-right
of screen
Projector
Computer1*
Component Video1
The image
(YCbCr ) *
source changes
Component Video1
each time
(YPbPr ) *
[Source] is
Computer2*
pressed.
Component Video2
If no S-Video
(YCbCr ) *
signal source is
Component Video2
connected, "S-
(YPbPr ) *
Video" will not
appear.
S-Video
Video
TIP
• If only one signal source has been connected, the signals from that
source will be projected without needing to press any of the buttons
on the remote control or the projector's control panel.
• If the "No Signal." message does not disappear, check the
connections again.
• If a laptop computer or a computer with an LCD screen has been
connected to the projector, the images may not be projected straight
away. After starting projection, check that the computer has been set
up to output signals externally.
The following table shows examples of how to toggle output settings.
For details, refer to the section of the documentation provided with
your computer under a heading such as "External output",
"Connecting an external monitor" or similar.
NEC Panasonic Toshiba IBM
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
• If the same still picture is projected for a long period of time, the
projected image may become burned in on the computer screen. You
should avoid leaving the same image displayed for long periods.
Sony Fujitsu Macintosh
After startup, change
the Control Panel
adjustments so that
Mirroring is active
34