Direct Button Operation - Sharp AQUOS LC-32D47UT Operation Manual

Direct Button Operation
You can change the volume by pressing VOL +/- on
the TV or on the remote control unR.
o To increase the volume, press VOL+.
o To decrease the volume, press VOL-.
Audio status
You can turn on the TV or put it on standby by
pressing POWER on the TV or on the remote control
unit. (See page 12.)
You can change channels by pressing CH/VV or
0-9, * (DOT).
Examples:
TO select a t or 2-digit channel number (e. g., Channel 5}:
Press 5 _ ENT.
To select a 3-digit channel number (e. g., Channel 115):
Press 1 _ 1 _ 5 _ ENT.
To select a 4-digit channel number (e. g., Channem22.1):
Press 2 _ 2 _ ®(DOT) _ 1 _ ENT.
, When selecting a 1 digR channel number, it is not necessary
to press 0 before the number.
, When you enter 0_9 only, channel selection will be made if
there is no operation within a few seconds.
, Ifyou push "0" by itself, nothing will happen.
, Complete the above steps within a few seconds.
, When you enter (F9 and • (DOT), channel sebction will be
made if there is no operation within a few seconds.
You can select 4 preset favorite channels in 4 different
categories.
Press A, B, C or D.
, While watching the TV, you can toggle the selected
channels by pressing A, B, C and D.
, See page 26 for details of favorite channel settings.
, When "Output Select" is set to "Variable", the indicator on
the screen changes as shown below.
I _ _f601
o See page 25 for details on the Output Select function.
Mutes the current sound output.
Press MUTE.
o ,,:_ ,,will be displayed on the screen for 30 minutes, and
the sound is silenced.
o Within 30 minutes of pressing MUTE, mute can be
canceled by pressing VOL+/- or MUTE.
o Mute will be canceled after 30 minutes have passed.
However, the TV will not suddenly output a loud sound as
the volume level is set to 0 automatically.
Allows you to set a time when the TV automatically
switches to standby.
Press SLEEP.
o The remaining time displays when the sleep timer has been
set.
o Each time you press SLEEP, the remaining time switches
as shown below.
0ff"_30_60"_90"_120
t !
o When set, the time automatically starts counting down.
o If you want to adjust the sleep timer, you can press SLEEP
twice then change the time setting.
o When it is 5 minutes before the time expires, the remaining
time will start to keep appearing every minute.
o Select "Off" by pressing SLEEP to cancel the sleep timer.
o The TV will enter standby when the remaining time reaches
0.
Press FLASHBACK to switch to the previously tuned
channek
Press FLASHBACK again to switch back to the currently
tuned channel.
FLASHBACK will not work if no channel has been changed
after the TV is turned on.
13