Table of Contents
Advertisement
Solutions
to Common
Problems
Before you call for service, review the following list. It may save you time & expense. The list includes
common occurrences that are not the result of defective workmanship
or materials in this appliance.
Problem
Solution
Appliance is not level
Be sure floor is level, strong & stable enough to
adequately support appliance.
If floor is sagging or sloping, contact a carpenter to
correct the situation.
Poor installation. Place oven rack in center of oven.
Place a level on the oven rack. Adjust leveling legs at
base of appliance until the oven rack is level.
• Kitchen cabinet alignment may make appliance appear
not level. Be sure cabinets are square & have sufficient
room for appliance clearance.
Cannot move appliance
easily.
Cabinets not square or are built in too tightly; Contact
.........
space so appliance can be lifted over carpet.
Surface burners do not light
Surface control knob has not been completely turned
to_
(lite). Push in and turn the surface control knob to
lite until burner ignites and then turn control knob to
desired flame size.
Burner ports are clogged. With the burners OFF, use a
small-gauge
wire or needle to clean ports. See
"Cleaning cooktop
and parts" in theOare and Cleaning
section for complete instructions.
Appliance
power cord is disconnected
from outlet. Be
sure power cord is securely plugged into the electrical
outlet.
• Electrical power outage.
Surface burner flame burns half way
around.
• Burner ports are clogged. With the burner OFF. clean
ports by using a small-gauge wire or needle.
• Moisture is present after cleaning. Lightly fan the flame
and allow burner to operate until flame is full. Dry the
burners thoroughly and follow instructions
under
"Cleaning cooktop and parts" in theCare and Cleaning
section.
Advertisement
Table of Contents
