Advertisement
Cycle
Settings
return to factory settings, press the Start/Pause and Select
For best
results
Follow the fabric care label
instructions on items to be
washed.
Appropriate Temperature,
Dryness level and Options will
automatically be displayed for each cycle. The settings can be
changed before the cycle is started.
If changes are attempted after the cycle starts, the lights will
blink, the signal will beep and "Err"
will be displayed.
Drying Temperature
To change the preset temperature, press the Temperature
button to scroll to the desired setting.
To protect your fabrics, not all temperatures are available with
every cycle.
The temperature selected for the cycle will be remembered and
recalled each time that cycle is selected in the future. To return
to factory settings, press the Start/Pause and Select buttons
at the same time and hold until the signal sounds.
_i _ :_::_ To change the temperature once the cycle has begun,
press the Pause button, make the new selection and press
Start again.
Maximum
High is recommended for sturdy fabrics.
High
High is recommended for regular fabrics.
Medium
Medium is recommended for wrinkle free, permanent press
and lightweight fabrics.
Low
Low is recommended for delicate fabrics.
Air fluff/No
Hea t
This setting (no heat) should only be used with a Timed
Dry cycle to dry items containing feathers, down, foam
rubber, plastics or rubber-like materials; to refresh clothing,
stuffed animal, pillows or blankets; and to dust draperies.
Dryness Level (Auto Dry)
To change the preset level, press the Dryness button to scroll
to the degree of dryness desired.
To protect your fabrics, not all Dryness levels are available
with every cycle. If a Dryness level is not appropriate for the
cycle, it cannot be selected.
The Dryness level selected for the cycle will be remembered
and recalled each time that cycle is selected in the future. To
buttons at the same time and hold until the signal sounds.
To change the Dryness level once the cycle has
begun, press the Pause button, make the new selection and
press Start again.
Select the Normal dryness level for most Auto Dry cycles.
Occasionally a load may seem too damp or over-dried at the
end of the cycle. To increase drying time for similar loads in
the future, select More Dry. For loads requiring less drying
time, select Less Dry.
Select Damp Dry for items you wish to partially dry before
hanging or ironing.
Cycle Options
: To select or delete the Shrink Guard, Extended
Tumble,
or Signal Volume, press Options until the blinking light
indicates the desired option. Then, while it is blinking, press
Select. The indicator will light when the option has been se-
lected. It will no longer be lighted when the option has been
removed.
Not all options are available on every model or are compatible
with every cycle. The indicator will not light if the option is
not available with that cycle.
To change the Options once the cycle has begun,
press the Pause button, make the new selection and press
Start again.
The options selected for the cycle will be remembered and
recalled each time that cycle is selected in the future. To
return to factory settings, press the Start/Pause and Select
buttons at the same time and hold until the signal sounds.
Shrink Guard
Select Shrink Guard to lower the initial drying temperature.
Extended
Tumble
Select Extended
Tumble if the dried load might not be
removed promptly at the end of the cycle. The dry load
will continue tumbling without heat for 30 minutes to help
reduce wrinkling. When the Signal is selected, a beep will
be heard periodically. The load may be removed any time
during Extended
Tumble.
Signal Volume
A signal will sound at the end of the cycle if this option is
selected. The signal has an adjustable volume level or can
be turned off.
Advertisement
