Advertisement
Care and
Cleaning,
continued
OUTSIDE
•
Clean the cabinet with mild soap and water. Never use harsh, gritty or
abrasive cleansers.
If the cabinet becomes stained, clean with diluted chlorine bleach (1 part
bleach to 8 parts water). Rinse several times with clear water.
Remove glue residue from tape or labels with a mixture of warm water and
mild detergent. Or, touch residue with the sticky side of the tape or label.
When cleaning chrome parts use a window cleaner with ammonia or mild
soap and water.
Before moving the dryer, place a strip of cardboard or thin fiberboard un-
der the front leveling legs to prevent damage to the floor.
Do not store or place laundry
products on top of dryer at any time. They can
damage the finish or controls.
Common
Drying
Problems
Many drying problems
involve poor cleaning
results, poor soil and stain removal, residues of lint and scum, and fabric damage.
For satisfactory
drying results, follow
these suggestions
provided by The Soap and Detergent
Association.
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break off,
ball up and cling
to fabric.)
Shrinking
Wrinkling
POSSIBLE CAUSES
o Fabricsoftener sheet.
Overloading.
Overdrying causes static
electricity.
Lint screen not clean when
cycle began.
Lint is attached to "pills."
SOLUTIONS
Rub fabric softener stains with bar
soap. Rinse and rewash.
o
o
PREVENTIVE MEASURES
o
o
Reduce load size and rewash using
liquid fabric softener in the final
rinse.
Or, add a fabric softener sheet and
tumble without heat.
Use lint brush or roller to remove
lint.
Use a lint brush or shaver to re-
move pills.
,,
Add a few bath towels to small loads for
proper tumbling.
Some "silk-like" fabrics should be air
dried.
Use proper drying temperature.
Place fabric softener sheet on top of load
before starting the dryer.
Do not overload dryer.
Use fabric softener in washer or dryer to
reduce static electricity.
Remove items when they are slightly damp
to avoid overdrying.
Check that lint filter is clean and in place.
Overdrying.
_
Use fabric softener to lubricate fibers.
When ironing, use spray starch or fabric
finish on collars and cuffs.
Turn items inside out to reduce abrasion.
Irreversible condition.
o
o
o
o
o
o
o
Temperature too high.
Overdrying.
Overloading.
Leaving items in dryer after
cycle ends.
Reduce load size and tumble at
medium or low heat for 5-10
minutes.
Remove items immediately. Hang
or fold.
Follow fabric care label directions.
If shrinking is a concern, check load often.
Remove items while slightly damp and
hang or lay flat to complete drying.
Block knits into shape.
Do not overload dryer.
Remove items as soon as cycle ends.
10
Advertisement
