Using the Configuration Wizard
44
Configuring Your System and Network
The Configuration Wizard automatically appears the first time you connect to
the NAS server using a web browser. After that, you can access the wizard to
perform guided configuration tasks as follows:
Open the Command View NAS web interface by typing the IP address in
I
the address or location field of a web browser (you configured this
address during installation). The Wizard (shown below) guides you
through configuration.
or
Access the Wizard through the Configuration tab of the Command View
I
NAS web interface by clicking Configuration Wizard > Actions > Launch
Wizard.
Note
Do not use your browser's Forward, Back, or Refresh buttons
while the Configuration Wizard is running. Instead use the
Back and Next buttons in the Wizard.
Figure 1
Configuration Wizard