HP StorageWorks 8000 - NAS User Manual page 219

Table 1 Command View SDM Limitations
Tab
Configuration General Settings
Page Feature
Alias Name
Data
Resiliency
Automatic
Include
Auto Format
Drive
Subsystem
Level RAID
Control
Hot Spare
Mode
Queue Full
Threshold
Port ID
Port Behavior Do not change this setting or attached
Port Topology Do not change this setting or attached
Limitations
No Limitations
Normal. Do not
Warning: This is set to
changes this setting. Changing this can
affect the integrity of the data in the event
of a system crash or power failure.
Do not turn this feature off. New disc
drives may not be recognized.
Do not turn this feature off. New disc
drives may not be available.
This is set to AutoRAID. You may choose
any setting. Be sure to understand the
storage capacity & performance
implications before changing this setting.
This is set to Automatic. Do not change this
setting to None. An active spare should be
present to ensure data integrity in the
event of multiple drive failures.
Do not change this setting.
This setting should be altered when
multiple storage arrays are attached via a
switch to ensure that each array is given a
unique ID. This is done using the virtual
front panel at hardware setup time. This
should be performed by an qualified HP
technician.
arrays will not be visible to the NAS
server.
arrays will not be visible to the NAS
server.
Command View SDM Limitations 217