LG LP1200DXR User's Manual & Installation Instructions page 11

HO\ /lO USE
USING THE CONTROLS
FAN SPEED
Pressing the F.4NSPEEB button cycles the
circulation fan speed from low (F1) to medium
(F2) to high (F3). The selected
fan speed will be shown in the
display. The function can be
used in either COOL or FAN
modes. When changing fan
speeds, there is a brief delay before the fan
motor changes speed.
TEMP/TIMER A / V
In COOL and DRY modes, the TEMPZrlMERA/V
buttons adjust the set temperature up to 86°F or
down to 60°F, in one degree
increments. The temperature is
in degrees Fahrenheit. It can
NOT be switched to degrees
Celsius.
When the TIMER function is selected, use the
TEMP/T/MERA / V buttons to adjust the delay
time from 1 to 24 hours, in one hour increments.
If you press and hold the TEMPZr/MERA / V
buttons, the set temperature or time will change
automatically after a few seconds.
NOTE: The displayed temperature is the SET
temperature, not the room temperature. In
COOL or DRY mode, the thermostat in the air
conditioner will run the compressor until the
set temperature is reached, then cycle the
compressor on and off to maintain the set
temperature.
TIMER 1-24 Hr
When the TIMERfunction is selected, you can set
the air conditioner to either automatically turn
OFF or turn ON after a delay of
up to 24 hours. The display will
show 0. Use the TEMP/T/MERA/
V buttons to adjust the delay
time from 1 to 24 hours, in one
hour increments.
To set an automatic off delay, press the TIMER
button while the air conditioner is running and
use the TEMP/TIMERA / V buttons to adjust the
delay time. The timer indicator will light. The air
conditioner will automatically turn OFF after the
set delay.
To set an automatic on delay, press the TIMER
button while the air conditioner is off and use
the TEMPZrlMERA / V buttons to adjust the
delay time. The timer indicator will light and the
display will show the number of hours remaining
until the unit is set to come on. The air
conditioner will automatically turn ON
after the set delay.
To cancel the Timer function, set the display to
"0". If you press and hold the TEMP/TIMER A/
V buttons.
NOTE: Do not unplug the air conditioner when
using the timer function.
11 @