Advertisement
PROB LEM
CAUSE
CORRECTION
"RECHARGE
OFF" is
The automatic Clean Rinse function
If you want the Clean Rinse function to run
flashing
in the display
has been disabled (See Page 16)
automatically, press and release the CLEAN
button until display no longer reads
"RECHARGE OFF" (See Page 16).
Error Code El, E3 or E4
Wiring harness or connections to
Replace wiring harness or connection to
appears
position switch
position switch (See parts list at end of this
manual).
Switch
Replace switch (See parts list at end of this
manual).
Valve defect causing high torque
Replace rotor/seal kit (instructions included
with kit).
Motor inoperative
Replace motor (instructions included with
motor)
Error Code E5 appears
Electronic control
Replace electronic control board (PWA)
(instructions included with PWA).
Procedure
for removing
error code from display:
1. Unplug transformer from electrical outlet.
2. Correct problem.
3. Plug in transformer.
4. Wait 6 minutes. The error code will return if the problem was not corrected.
Assistance
from customer
service
may be needed
with the following:
PROBLEM
CAUSE
CORRECTION
Water running
to the
Inner valve defect causing leak
Replace seals and rotor
drain (while unit is not in
the Clean Rinse cycle)
Filter media in house-
Crack in distributor or riser tube
Replace distributor or riser tube.
hold plumbing
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
20
Advertisement
